How to remove the front and rear bumper Toyota Corolla (since 2013)

-Under the hood, unscrew the screws and pull out the clips (screwed and inserted from top to bottom) and remove the radiator grille.
-Under the grille, pull out the clips (inserted from top to bottom).
-Along the perimeter of the lower part, unscrew the screws and pull out the pins (screwed and inserted from bottom to top), which secure the bumper to the protection.
-Turn the wheels to the left or right side, depending on which side we will disassemble first.
-In the wheel arches, pull out the clips and unscrew the screws.
-With an assistant, release the corners from the latches in the fenders and remove the bumper from the guides towards you.

-remove the connector from the fog lights (if any).
-remove the connector from the parking sensors (if any).
-if there are headlight washers, disconnect the hoses (to prevent the liquid from leaking onto the ground, you should prepare a special container).

Rear bumper

-open the trunk lid and unscrew one screw on each side in the opening.
-unscrew the screws in the wheel arches and pull out the pins that secure the fender liners.
-unscrew one screw on each side behind the fender liners (screwed from the bottom up).
-unscrew the screws along the perimeter in the lower part and pull out the pins (screwed and inserted from the bottom up).

-with an assistant, release the bumper from the latches in the fenders and under the taillights.
- pull it off the guides towards you.
- remove the connector from the parking sensor (if any).
Tags: