How to remove front and rear bumper Toyota Previa

-under the hood, unscrew the screws and pull out the clips (screwed and inserted from top to bottom), which secure the upper part of the bumper (radiator grille).
-unscrew the screws in the lower grille (they may not be there).
-unscrew the screws around the perimeter of the lower part (screwed from bottom to top).
-turn the wheels to the left or right side, depending on which side we will disassemble first.

-in the wheel arches, pull out the clips and unscrew the screws.
-move the fender liners to the side and unscrew the screws that secure the corners to the fenders.
-with an assistant, release the corners from the latches in the fenders and remove the bumper from the guides towards you.
-remove the connector from the fog lights (if any).
-remove the connector from the parking sensors (if any).
-if there are headlight washers, disconnect the hoses (to prevent the liquid from leaking onto the ground, you should prepare a special container).

Rear bumper

-open the trunk lid and unscrew one screw in the opening on each side (may not be there).
- remove the rear trim in the trunk.
- unscrew the nuts under the trim (you will need a head with a ratchet).
- unscrew the screws in the wheel arches and pull out the pins that secure the fender liners and mudguards (if any).
- move the fender liners to the side and unscrew one screw on each side in the corners.
- unscrew the screws along the perimeter at the bottom and pull out the pins (screwed in and inserted from the bottom up).

- with an assistant, release the bumper from the latches in the fenders and under the taillights.
- pull it off the guides towards you.
- remove the connector from the parking sensors (if any).
Tags: