СarSoftos.com » Materials for July 2023 year
Author: carsoftos777 | 12-07-2023, 03:00 | Programs for cars and diagnostics | Views: 2 552 | Comments: 0


Description: a collection of programs for working with ManCats 2, Man Immo, Man Editor.
  • LIKE
  • 1
How to remove the front and rear bumper Cadillac CTS (2008-2014)


-open the hood.
-under the hood, take out the caps and remove the trim (if any).
-under the hood, Unscrew the two screws and take out the caps that secure the top.
-around the bottom of the take out the caps and Unscrew the screws that attach the bumper to the fender liner and protection.
-turn out the wheels (depending on which side we will disassemble).
-in the wheel wells take out the caps and release the fender liner.
-for the fender liner, Unscrew the screws that secure the corners of the bumper to the wings.
-we release the latch in the wings (pull the corners towards you).
  • LIKE
  • 1
Author: carsoftos777 | 12-07-2023, 02:52 | How To Remove Bumpers | Views: 255 | Comments: 0


Below are the wiring diagrams for the bumpers. The arrows indicate the location of the screws, caps and latches.
  • LIKE
  • 1
Author: carsoftos777 | 6-07-2023, 20:55 | Programs for cars and diagnostics | Views: 7 028 | Comments: 2


Description: Dealer software for PEUGEOT & CITROEN car diagnostics (Also Works with mitsubishi Lancer X ,ASX, XL).

  • LIKE
  • 8
How to remove the front and rear bumper Subaru B9 Tribeca (2005-2007)


-open the hood.
-under the hood take out the caps that secure the trim and the top, remove the trim.
-turn the wheels, depending on which side we will disassemble.
  • LIKE
  • 1
How to remove the front and rear bumper Cadillac CTS (2003-2007)


-open the hood.
-under the hood, remove the trim over the grille.
  • LIKE
  • 1


Description: — New versions of Porsche Piwis Tester (41.600 + 38.250);
— Full FAP diagnostic protocol;
— Complete electronic circuits of Porsche cars;
- Reading, decoding, deleting fault codes;
— Reset service intervals;
— View and save the flow of current data;
- View freeze frames of faults;
— Tests of actuators and electronic units;
— Guided troubleshooting for 2021 (Online and Offline);
  • LIKE
  • 1
Author: carsoftos777 | 6-07-2023, 16:13 | How To Remove Bumpers | Views: 252 | Comments: 0


Below are the wiring diagrams for the bumpers. The arrows indicate the location of the screws, caps and latches.
  • LIKE
  • 1
Author: carsoftos777 | 6-07-2023, 15:54 | How To Remove Bumpers | Views: 273 | Comments: 0
How to remove front and rear bumper BMW 7-series E38


-unscrew the wheels left or right, depending on which side you will unscrew first
-in the wheel wells, Unscrew the bolts (8mm) that attach the fender liner to the bumper.
-at the edges of the fog lights, closer to the center of the bumper, Unscrew one bolt (under the inner sprocket) on each side (spun up).
-in the lower part at the corners of the bumper, depress the latches and pull the bumper slightly forward.
  • LIKE
  • 1
Author: carsoftos777 | 4-07-2023, 00:03 | Programs for cars and diagnostics | Views: 1 639 | Comments: 0
Carista 8.0 Pro Full


Description: Carista OBD2 Sees ALL blocks, errors on them, resets errors. Maybe something to configure, encode.
The program significantly increased the number of readable blocks by the engine ECU, the program allows you to read and erase the errors of the ABS.AIR BAG blocks AND NOT ONLY.
  • LIKE
  • 3