How to remove the front and rear bumper of a Toyota Corolla Verso

Until 2007, the radiator grille is removed separately from the bumper. Otherwise, the mounting locations are similar.
-Unscrew two screws under the hood and take out three clips (screwed in and inserted from top to bottom) that secure the upper part of the bumper (radiator grille).
-Unscrew two screws under the radiator grille (screwed in from top to bottom) before 2007.
-Unscrew the screws around the perimeter of the lower part (screwed in from bottom to top).
-Turn the wheels to the left or right, depending on which side we will disassemble first.
-Take out the clips in the wheel arches and unscrew the screws.
-move the mudguards to the side and unscrew one screw at a time (screwed from the bottom up) that secure the corners to the fenders.

-with an assistant, release the corners from the latches in the fenders and remove the bumper from the guides towards you.
-remove the connector from the fog lights (if any).
-remove the connector from the parking sensors (if any).
-if there are headlight washers, disconnect the hoses (to prevent the liquid from leaking onto the ground, you should prepare a special container).

Rear bumper

-open the trunk lid and unscrew one screw on each side in the opening (may not be there).
-remove the rear trim in the trunk.
-unscrew two nuts under the trim (you will need a head with a ratchet).
-unscrew the screws in the wheel arches and pull out the pins that secure the fender liners and mudguards (if any).
-unscrew the screws along the perimeter in the lower part and pull out the pins (screwed and inserted from the bottom up).

-with an assistant, release the bumper from the latches in the fenders and under the taillights.
- pull it off the guides towards you.
- remove the connector from the parking sensors (if any).
Tags: