How to remove the front and rear bumper of a Toyota Avensis MK3 (from 2008)

-under the hood, unscrew the screws and take out the pistons (twisted and inserted from top to bottom) that secure the upper part of the bumper and the radiator grille to the upper bar.
-under the car, unscrew the screws around the perimeter (twisted from bottom to top) that secure the lower part.
-turn the wheels to the left or right, depending on which side we will disassemble first.
-in the wheel arches, Unscrew the screws that secure the fender liners.
-move the fender liners to the side and remove one screw on each side (twisted from bottom to top) that secures the corners to the wings.

-with an assistant, we tear off the corners from the latches in the wings and pull the bumper off the guides towards us.
- if there are headlight washers, disconnect the hoses. You should prepare a container for the windshield washer in advance.
-remove the connector from the parking sensors (if equipped).
-remove the connector from the fog lights (if equipped).

Rear bumper

-open the trunk lid and unscrew one screw on each side in the opening.
-in the wheel arches, unscrew the screws and take out the pistons that secure the fender liners.
-move the fender liners to the side and unscrew one screw on each side (twisted from bottom to top) that secure the corners to the wings (they may not be there).
-take out the caps and unscrew the screws around the perimeter at the bottom (inserted and twisted from bottom to top) (there can only be caps).

-with an assistant, release the bumper from the latches in the wings and under the rear lights and pull it off the guides towards you.
-if there are parking sensors, remove the connector.
Tags: