How to remove front and rear bumper VW Golf 6

-unscrew the wheels to the left or right, depending on which side you will disassemble.
-in the wheel arches, unscrew the screws that secure the fender liners to the bumper.
-behind the fender liners, unscrew one screw on each side (screwed from bottom to top), which secure the corners of the bumper to the body.
-open the hood and remove the radiator grille. In the upper part, unscrew four screws (screwed from top to bottom), pull the lower part towards you (held by latches).
-under the grille, unscrew the screws, one near the headlights.

-unscrew the screws along the entire length of the lower part of the bumper (screwed from bottom to top).
-pull the corners and pull the bumper off the guides towards you.
-remove the connectors from the fog lights.
-if there are headlight washers, disconnect the hose and plug it with a plug so that liquid does not leak out of the tank.

Rear bumper

-in the wheel arches, unscrew the screws that secure the mudguards to the bumper and the bumper to the wing (in order not to remove the wheels, you can use a ratchet with a nozzle).
- from under the car, at the bottom of the bumper, unscrew four screws (screwed from the bottom up).
- pull the side trims of the trunk to the sides (you need to get access to the taillights).
- unscrew two nuts on each side and remove the taillights.
- under the taillights, unscrew the screws (screwed from top to bottom).

-pull the edges to the sides, tearing them off the latches (this needs to be done by two people) and pull the bumper back.
-remove the connector from the license plate light.
-remove the connector from the parking sensors (if any).
-the bumper is removed.
Tags: