How to remove the front and rear bumper of a Peugeot 408

-open the hood.
-under the hood, unscrew the two screws and take out the pistons that secure the upper part.
-around the perimeter of the lower part, Unscrew the seven screws that secure the lower part.
-depending on which side we will disassemble, turn the wheels out.
-in the wheel arches we release the fender liners (you don’t have to remove them completely).
-behind the fender liners, Unscrew the screws that secure the corners to the wings.

-release the latches in the wings (pull the corners toward you).
-pull the bumper forward (make sure not to tear the wires and hoses).
-remove the connectors from the fog lights (if any).
-(if any) disconnect the washer hoses (liquid may leak).

Rear bumper

-in the wheel arches we release the fender liners (you don’t have to remove them completely).
-behind the fender liners, Unscrew one screw on each side that secures the corners of the bumper to the wings.
-Unscrew the screws that secure the lower part (twisted from bottom to top).
-in the trunk, remove the rear (take out three pistons and tear them up from the latches) and side (held on by pistons) trim.
-Unscrew the nuts from the trunk and pull out the rear lights.

-release the latches under the rear lights.
-release the latches in the wings (pull the corners toward you).
-with an assistant, carefully (making sure not to break the wires) pull the bumper back.
-remove the connectors from the electrical equipment.
Tags: