How to remove front and rear bumper Toyota IQ

-under the hood we take out five pins (inserted from top to bottom), which secure the upper part of the bumper.
-along the perimeter of the lower part we unscrew the screws (screwed from bottom to top).
-turn the wheels to the left or right side, depending on which side we will disassemble first.
- in the wheel arches, unscrew the screws and pull out the clips that secure the mudguards.

- with an assistant, release the corners from the latches in the wings and remove the bumper from the guides towards you.
- remove the connector from the fog lights (if any).
- remove the connector from the parking sensors (if any).
- if there are headlight washers, disconnect the hoses (to prevent the liquid from leaking onto the ground, you should prepare a special container).

-open the trunk lid and unscrew one screw on each side in the opening.
-unscrew the screws along the perimeter in the lower part and pull out the clips (screwed and inserted from the bottom up).
-unscrew the screws in the wheel arches that secure the fender liners.
-with an assistant, release the bumper from the latches in the fenders and under the taillights.

-pull it off the guides towards you.
-remove the connector from the parking sensors (if any).
-remove the connector from the license plate light.