How to Remove Front and Rear Bumper Toyota Corolla (2006-2013)

-Under the hood, unscrew the screws and pull out the clips (screwed and inserted from top to bottom) that secure the upper part of the bumper.
-Along the perimeter of the lower part, unscrew the screws (screwed from bottom to top).
-Pull out two clips in the opening of the lower radiator grille.
-Turn the wheels to the left or right side, depending on which side we will disassemble first.
-In the wheel arches, pull out the clips that secure the fender liners.

-with an assistant, release the corners from the latches in the wings and remove the bumper from the guides towards you.
-remove the connector from the fog lights (if any).
-remove the connector from the parking sensors (if any).

-if there are headlight washers, disconnect the hoses (to prevent the liquid from leaking onto the ground, you should prepare a special container).

Rear bumper

-open the trunk lid and unscrew one screw on each side in the opening.
-unscrew the screws in the wheel arches and pull out the pins that secure the fender liners.
-pull out the pins around the perimeter in the lower part (inserted from bottom to top).

-with an assistant, release the bumper from the latches in the fenders, under the taillights and the trunk opening.
- pull it off the guides towards you.
- remove the connector from the parking sensors (if any).
Tags: