How to remove the front and rear bumper Toyota Highlander XU 20 (2001-2007)

-under the hood, pull out the clips and remove the radiator grille (the lower part is held on by latches).
-unscrew the screws along the perimeter of the lower part (screwed from the bottom up).
-turn the wheels to the left or right side, depending on which side we will disassemble first.
-in the wheel arches, unscrew the screws and pull out the clips that secure the fender liners.

-Unscrew one screw on each side behind the fenders (screwed from bottom to top).
-With an assistant, release the corners from the latches in the fenders and remove the bumper from the guides towards you.
-Remove the connector from the fog lights (if any).

-Remove the connector from the parking sensors (if any).
-if there are headlight washers, disconnect the hoses (to prevent the liquid from leaking onto the ground, you should prepare a special container).

Rear bumper

-open the trunk lid and unscrew the screws in the opening and pull out the pins.
- remove the rear trim (fastened with latches).
-under the trim, unscrew the four nuts (you will need a head with a ratchet).
-unscrew the screws along the perimeter in the lower part and pull out the clips (screwed and inserted from the bottom up).
-unscrew the screws in the wheel arches that secure the mudguards.
-with an assistant, release the bumper from the latches in the fenders.

-pull it off the guides towards you.
-remove the connector from the parking sensor (if any).
-remove the connectors from the additional equipment (if any).
Tags: