How to remove the front and rear bumper SEAT Leon III (after 2013)

Depending on the model variant, the mounting locations may differ.
-Unscrew four screws under the hood (screwed from top to bottom).
-Unscrew one screw on each side in the central decorative grille.
-Unscrew the screws around the perimeter at the bottom (screwed from bottom to top).
-Turn the wheels to the left or right, depending on which side we will disassemble first.
-Unscrew the screws in the wheel arches that secure the fender liners.
-Move the fender liners to the side and unscrew one screw on each side in the corners.

-with an assistant, we tear off the corners from the latches and pull the bumper off the guides towards ourselves.
-remove the connector from the parking sensors (if any).
-remove the connector from the fog lights.
-if there are headlight washers, disconnect the hoses. To prevent the liquid from leaking onto the ground, you need to prepare a suitable container.

Rear bumper

Depending on the model version, the mounting locations may differ.
- remove the plugs in the side trims.
- unscrew the fastening handles under the plugs, move the taillights to the sides and remove them from the latches.
- unscrew the screws under the taillights and pull out the pins.
- unscrew the screws in the wheel arches that secure the mudguards (in order not to remove the wheels, it is more convenient to unscrew them with a ratchet with a nozzle).
- move the mudguards to the side and unscrew one screw on each side (screwed from the bottom up).

- unscrew the screws along the perimeter at the bottom (screwed from the bottom up).
- with an assistant, tear off the corners from the latches and pull the bumper off the guides towards you.
- remove the connector from the license plate light.
- remove the connector from the parking sensor (if any).
Tags: