How to remove the front and rear bumper SEAT Toledo II (1998-2005)

Depending on the model variant, the mounting locations may differ.
-Unscrew four screws under the hood (there may be pistons) (screwed from the bottom up).
-Remove the upper side trims (may not be there) and the lower plugs (you need to carefully pry the edge with a screwdriver and tear it off the latches).
-Unscrew the screws under the trims and plugs.
-Unscrew three screws at the bottom of the bumper (screwed from the bottom up).

-turn the wheels to the left or right side, depending on which side we will disassemble first.
-unscrew the screws in the wheel arches that secure the fender liners.
-with an assistant, pull the bumper off the guides towards you.

-remove the connector from the parking sensors (if any).
-remove the connector from the fog lights.
-if there are headlight washers, disconnect the hoses. To prevent the liquid from leaking onto the ground, you need to prepare a suitable container.

Rear bumper

Depending on the model variant, the mounting locations may differ.

-unscrew one bolt on each side in the trunk opening.
-unscrew the screws in the wheel arches that secure the mudguards and the screws that secure the corners to the guides (in order not to remove the wheels, it is more convenient to unscrew with a ratchet with a nozzle).
-move the mudguards to the side and unscrew one screw on each side (screwed from the bottom up).

-unscrew the screws around the perimeter at the bottom (screwed from bottom to top).
-with an assistant, pull the bumper off the guides towards you.
-remove the connector from the parking sensor (if any).
Tags: