How to remove front and rear bumper SEAT Ibiza MK4 (after 2008)

Depending on the year of manufacture and model variant, the mounting locations differ slightly.
-open the hood and pull out the pins that secure the upper part of the bumper.
-turn the wheels to the left or right side, depending on which side we will disassemble first.
-unscrew the screws in the wheel arches that secure the fender liners.
-move the fender liners to the side and unscrew one screw on each side in the corners (screwed from bottom to top).

-unscrew the screws around the perimeter at the bottom (screwed from the bottom up).
-with an assistant, tear off the corners from the latches and pull the bumper off the guides towards you.
-remove the connector from the parking sensors (if any).
-remove the connector from the fog lights.
-if there are headlight washers, disconnect the hose from the washer reservoir pump. To prevent the liquid from leaking onto the ground, you need to prepare a suitable container.

Rear bumper

Depending on the year of manufacture and model variant, the mounting locations differ slightly.
mounting locations of the rear bumper SEAT Ibiza MK4 (after 2008) - in the trunk, unscrew the clamps and remove the taillights.
- under the taillights, unscrew two screws on each side (screwed from top to bottom).
- unscrew one screw on each side in the trunk opening.
- unscrew the screws in the wheel arches that secure the mudguards (in order not to remove the wheels, it is more convenient to unscrew with a ratchet with a nozzle).

-move the mudguards to the side and unscrew one screw on each side (screwed from the bottom up) (may not be).
-unscrew the two screws that secure the lower skirt (may not be).

-unscrew the screws around the perimeter at the bottom (screwed from the bottom up).
- with an assistant, we tear off the corners from the latches and pull the bumper off the guides towards ourselves.
- remove the connector from the license plate light.
- remove the connector from the parking sensor (if any).
Tags: