How to remove the front and rear bumper of a VW Jetta 6

-we unscrew the wheels to the left or right, depending on which side you will disassemble.
-in the wheel arches, Unscrew the screws that secure the fender liners to the bumper.
-Unscrew the screws that secure the bumper to the wings (twisted from bottom to top).
-open the hood and Unscrew the four screws that secure the radiator grille.
- pull the grille off the latches in front as the car moves
-at the very bottom, along the entire length, unscrew the seven screws that secure the engine protection and fender liners.
- tear the bumper off the latches (pull the edges away from the car) and pull it into the front (you need to do this with an assistant so as not to scratch the paint on the wings).

-now you can disconnect the connectors from the fog lights (if any).
-remove the connector from the parking sensors (if equipped).
- if there are headlight washers, disconnect the hoses from the injectors and close them with plugs so that liquid does not leak out of the reservoir.

Rear bumper

-in the wheel arches, unscrew the screws that secure the fender liners to the bumper (in order not to remove the wheels, you can use a ratchet with an attachment).
-In the corners, unscrew one screw on each side that secures the bumper to the wings (twisted from bottom to top).
-unscrew the screws (twisted from bottom to top) and take out the caps around the perimeter at the bottom of the bumper.
-now you need to gain access to the inside of the rear lights. In the trunk, remove the side trims, unscrew the fastening nuts and remove the rear lights.
-under the rear lights, disconnect the latches.

-tear off the bumper from the latches (pull the edges to the sides) and pull it back (you need to do this with an assistant so as not to scratch the paint on the wings).
-remove the connector from the parking sensors (if equipped).
Tags: