How to remove the front and rear bumper of a Chrysler 300C (after 2011)

-under the hood we take out the eight pistons (inserted from top to bottom) that secure the upper part.
-Unscrew the screws around the perimeter at the bottom.

-turn the wheels left or right, depending on which side you will disassemble.
-in the wheel arches we take out three pistons on each side and release the fender liners.

-behind the wheel arch liners, Unscrew one screw on each side that secures the corners.

-we release the latches in the wings (pull the corners toward you) and between the upper part and the wings above the headlights (you need to pry them off with a flat screwdriver).
-with an assistant we pull the bumper onto ourselves.
-remove the connectors from the electrical equipment (if any).
-disconnect the headlight washer hoses.

Rear bumper

-in the wheel arches we take out three pistons on each side that secure the fender liners.
-move the fender liners to the side and unscrew one screw on each side that secures the corners of the bumper to the wings (twisted from bottom to top).

-around the perimeter in the lower part we take out the four pistons and unscrew the six screws (twisted and inserted from the bottom up).
-release the latches in the wings (pull the corners toward you) and in the trunk opening.

- with an assistant, pull the bumper off the guides towards you.
-remove the connectors from the electrical equipment (if any).
Tags: