How to Remove Front and Rear Bumper Toyota Sequoia (2001-2007)

-open the hood and pull out three pistons behind the front bar (there may be screws).
-unscrew the screws along the perimeter of the lower part and pull out the pistons (screwed and inserted from the bottom up).
-turn the wheels to the left or right side, depending on which side we will disassemble first.
-in the wheel arches, unscrew the screws that secure the fender liners to the bumper.
-move the fender liners to the side and unscrew one screw on each side (screwed from the bottom up), which secure the corners to the fenders.

-with an assistant, release the corners from the latches in the wings and remove the bumper from the guides towards you.
-remove the connector from the fog lights (if any).
-remove the connector from the parking sensors (if any).
-if there are headlight washers, disconnect the hoses (to prevent the liquid from leaking onto the ground, you should prepare a special container).

Rear bumper

-open the trunk lid, unscrew two screws on each side at the edges and remove the threshold trim.
-unscrew six screws behind the trim that secure the upper part of the bumper.
-unscrew the screws in the wheel arches and pull out the pins that secure the fender liners (in order not to remove the wheels, it is more convenient to unscrew with a ratchet with a nozzle).
-move the fender liners to the side and unscrew one screw on each side that secure the corners to the fenders.
-unscrew the screws around the perimeter at the bottom and pull out the pins (screwed in and inserted from the bottom up).

-with an assistant, release the bumper from the latches in the fenders and remove it towards you.
-remove the connector from the parking sensor (if any).
-remove the connectors from the additional equipment (if any).
Tags: