How to Remove Front and Rear Bumper Toyota Tundra (2007+)

-turn the wheels to the left or right side, depending on which side we will disassemble first.
-unscrew the screws in the wheel arches and pull out the pins that attach the fender liners to the bumper.
-move the fender liners to the side, unscrew the screws and pull out the pins that attach the corners of the lining to the fenders.
-open the hood, unscrew two screws on each side under the headlights and remove the linings.
-unscrew the screws along the perimeter in the upper part and pull out the pins (screwed and inserted from top to bottom).

- remove the bumper trim and unscrew two screws on each side under it (screwed from top to bottom).
- unscrew the screws along the perimeter of the lower part (screwed from bottom to top).
- with an assistant, release the corners from the latches in the fenders and remove the bumper from the guides towards you.
- remove the connector from the fog lights (if any).

- remove the connector from the parking sensors (if any).
-if there are headlight washers, disconnect the hoses (to prevent the liquid from leaking onto the ground, you should prepare a special container).

Rear bumper

-unscrew the screw in the middle of the central bumper trim.
-release the bumper trims from the latches and remove.
-unscrew the screws under the trims (screwed from top to bottom).

-unscrew the two screws at the bottom (screwed from the bottom up).
-with an assistant, remove the bumper from the guides towards you.

-remove the connector from the parking sensor (if any).
-remove the connectors from the additional equipment (if any).
Tags: