How to Remove Front and Rear Bumper Toyota Sienna XL30 (After 2010)

-under the hood, pull out the pins (inserted from top to bottom), which secure the radiator grille.
-release the lower part from the latches and remove the radiator grille.
-unscrew the screws along the perimeter of the lower part (screwed from bottom to top).
-turn the wheels to the left or right side, depending on which side we will disassemble first.
-in the wheel arches, unscrew the screws and pull out the pins that secure the fender liners to the bumper.

-with an assistant, release the corners from the latches in the wings and remove the bumper from the guides towards you.
-remove the connector from the fog lights (if any).
-remove the connector from the parking sensors (if any).
-if there are headlight washers, disconnect the hoses (to prevent the liquid from leaking onto the ground, you should prepare a special container).

Rear bumper

-open the trunk lid.
-in the corners of the opening, pull out the plugs and unscrew two screws under them on each side.
-in the wheel arches, unscrew the screws and pull out the pins that secure the fender liners and mudguards to the bumper (in order not to remove the wheels, it is more convenient to unscrew with a ratchet with a nozzle).

-unscrew the screws around the perimeter at the bottom (screwed from bottom to top).
-with an assistant, release the bumper from the latches in the fenders and remove it towards you.

-remove the connector from the parking sensor (if any).
-remove the connectors from the additional equipment (if any).
Tags: