СarSoftos.com » How To Remove Bumpers » How to remove the front and rear bumper Toyota Highlander XU 40 (2008-2013)

How to remove the front and rear bumper Toyota Highlander XU 40 (2008-2013)

Author: carsoftos777 | 13-09-2024, 02:33 | How To Remove Bumpers | Views: 4 196 | Comments: 0 | Found a bug?


-open the hood and unscrew the screws and pull out the pins (inserted and screwed from top to bottom), remove the air intake.
-under the air intake, unscrew the screws and pull out the pins that secure the radiator grille.
-release the grille from the latches and remove.
-pull out the pin under the grille.
-unscrew the screws along the perimeter of the lower part (screwed from bottom to top).

-turn the wheels to the left or right side, depending on which side we will disassemble first.
-in the wheel arches, unscrew the screws and pull out the clips that secure the fender liners.
-with an assistant, release the corners from the latches in the fenders and remove the bumper from the guides towards you.
-remove the connector from the fog lights (if any).

-remove the connector from the parking sensors (if any).
-if there are headlight washers, disconnect the hoses (to prevent the liquid from leaking onto the ground, you should prepare a special container).

Rear bumper





-open the trunk lid and unscrew one screw on each side in the opening.
-unscrew the screws along the perimeter at the bottom and pull out the clips (screwed in and inserted from the bottom up).
-unscrew the screws in the wheel arches that secure the fender liners.
-with an assistant, release the bumper from the latches in the fenders and under the taillights.

-pull it off the guides towards you.
-remove the connector from the parking sensor (if any).
-remove the connectors from the additional equipment (if any).
  • LIKE
  • 1

Tags:
Information
Users of Guests are not allowed to comment this publication.