How to remove the front and rear bumper Subaru Legacy (Outback) (Levorg) (after 2014) BN, BS

-open the hood.
-under the hood, take out the pins that secure the upper part of the bumper.
-take out the pins (inserted from bottom to top) along the perimeter of the lower part.
-turn the wheels depending on which side we are going to disassemble.
-in the wheel arches, take out the pins that secure the fender liners and bumper corners to the fenders.

-with an assistant, release the latches in the fenders and under the headlights and carefully pull the bumper forward (be careful not to tear the wires).
-remove the connectors from the electrical equipment (if any).

Rear bumper

-open the trunk lid.
-in the trunk opening, pull out the plugs and unscrew the two screws under them.
- pull out the pins around the perimeter of the lower part (inserted from the bottom up).
- pull out the pins in the wheel arches and release the fender liners.
- with an assistant, carefully release the latches in the fenders and under the taillights.

- pull the bumper back.
- disconnect the electrical equipment connectors (if any).
Tags: