How to remove the front and rear bumper of Acura TSX (2008-2014)

-open the hood.
-under the hood we take out the eight pins that secure the trim above the radiator grille and the upper part.
- along the perimeter of the lower part we take out twelve pistons (inserted from bottom to top).

-turn out the wheels (depending on which side we will disassemble).
-in the wheel arches, Unscrew one screw on each side that secures the corners to the wings.
-tear off the latches in the wings (pull the corners toward you).

-release the latches under the headlights (pull the corner and pull it forward).

-with an assistant, pull the bumper forward (make sure not to break the wires).
-remove the connectors of the electrical equipment.

Rear bumper

-open the trunk lid.
-in the trunk opening, take out two plugs.
-under the plugs, Unscrew the screws that secure the upper part.
-along the perimeter of the lower part we take out two pistons and unscrew the four screws (twisted and inserted from the bottom up).

-in the wheel arches, unscrew two screws on each side (in order not to remove the wheels, it is better to unscrew them using a ratchet with an attachment) that secure the fender liners.
-move the fender liners to the side and unscrew one screw on each side (twisted from bottom to top) that secure the corners of the bumper to the wings.
-release the latches in the wings (take it by the corner and pull it towards you).

-release two latches on each side under the rear lights.
-we tear off the latches in the trunk opening (pull it back).

-with an assistant, carefully pull the bumper back (make sure not to break the wires).
-remove the connectors from the electrical equipment (if any).
Tags: