How to remove the front and rear bumper of Acura RDX (2006-2012)

-open the hood.
-under the hood, take out the pistons and Unscrew the screws that secure the upper part.
-around the perimeter of the lower part, unscrew two screws and take out seven pistons (twisted and inserted from bottom to top).
-depending on which side we will disassemble, turn the wheels to the side.
-in the wheel arches, unscrew two screws on each side and release the fender liners.
-release the latches in the wings (pull the corners toward you).

-release the latches under the headlights.
-with an assistant, pull the bumper forward (make sure not to tear the wires and hoses).

-remove the connectors from the fog lights (if any).
-(if any) disconnect the washer hoses (liquid may leak).

Rear bumper

-open the trunk lid.
-in the trunk opening, take out the plugs and unscrew two screws under them on each side.
-take out the four pistons (inserted from bottom to top) at the bottom.
-in the wheel arches we unscrew the screws that secure the fender liners and the corners of the bumper to the wings.

-release the latches in the wings (pull the corners toward you).
-release the latches under the rear lights and in the trunk opening.

-with an assistant, carefully pull the bumper back (make sure not to break the wires).
-remove the connectors from the electrical equipment (if any).
Tags: