How to remove front and rear bumper Peugeot Expert 3 (Citroën Jumpy, Fiat Scudo) (2006-2016)

-open the hood.
-under the hood take out the four pistons and remove the grille up.
-take out the caps under the grille that secure the top.
-on the perimeter of the lower part, Unscrew the screws and release the clamps.
-depending on which side we will disassemble turn the wheels.

-in the wheel wells, Unscrew the screws, take out the caps and release the fender liner.
-Unscrew one screw on each side that attach the corners to the wings.
- (the most difficult) through the wheel arches you need to turn 90 degrees in the wings, two clamps on each side (you need to make a hook from steel wire).

-pull the bumper forward from the rails (be careful not to break the wires).
-remove connectors from electrical equipment (if any).

Rear bumper

-open the lid (doors) of the trunk.
-in the opening of the trunk, Unscrew the six screws.
-in the wheel wells, Unscrew the screws that attach the corners to the wings.
-Unscrew the screws (nuts) that secure the lower part.

-carefully pull the bumper back (be careful not to break the wires).
-remove the connectors from the parking sensors (if any).
Tags: