How to remove the front and rear bumper Renault Captur (Kaptur)

Depending on the year of manufacture, the attachment points may differ.
Front bumper
-open the hood.
-under the hood, Unscrew the four screws and take out the two pistons that secure the trim over the grille.
-we release the hood latch cable.
-depending on which side we will disassemble, turn the wheels.
-we release the lining of the wings (hold on the latches, starting from the bottom, pull towards you).
-in the wheel wells, take out the caps and release the fender liner (no need to remove).

-for the fender liner, Unscrew one screw on each side that attach the corners of the bumper to the wings.
-on the perimeter of the lower part, Unscrew the seven screws (spun up).
-we release the latch in the wings (pull the corners towards you).
-pulls the bumper forward (be careful not to break the wires).
-remove connectors from electrical equipment (if any).

Rear bumper

-Open the trunk lid.
-in the opening of the trunk, Unscrew three screws on each side (attach the central part of the bumper and taillights) and pull out the taillights (they sit tight).
-we release the lining of the wings (hold on the latches, starting from the bottom, pull towards you).
-in the wheel wells, Unscrew one screw on each side that attach the corners of the bumper to the wings.
-Unscrew the eight screws that secure the bottom.

-we release the latch in the wings (pull the corners towards you).
-pulls the bumper back (look behind the wires).
-disconnect electrical connectors.
Tags: