How to remove front and rear bumper Peugeot 806 (Fiat Ulysse, Citroën Evasion, Lancia Zeta)

-open the hood.
-under the hood, Unscrew the screws, release the latches and remove the grille.
-release the latches and pull out the direction indicators.
-Unscrew three screws on each side and remove the headlights.

-under the headlights, unscrew one screw from each side of the Peugeot 806 front bumper.
-on the perimeter of the lower part, Unscrew the screws (spun up).

-through the openings of the headlights, Unscrew two nuts on each side (spun from the side of the engine compartment) that secure the bumper amplifier to the body (in some cases, the amplifier may remain on the body).
-(if any) Unscrew the screws under the license plate.

-in the wheel arches release the fender liner.
-pulls the bumper forward from the guides in the wings (be careful not to break the wires).
-remove connectors from electrical equipment (if any).




-Unscrew the screws that secure the bottom.
-in the wheel wells, Unscrew the screws and release the fender liner.
-for the fender liner, Unscrew one screw on each side that secures the sides to the wings.
-Open the trunk lid.

-in the opening of the trunk, Unscrew the two screws.
-with an assistant, gently pull the bumper back, making sure not to break the wires.
-disconnect electrical connectors (if any).
Tags: