How to remove the front and rear bumper Chevrolet Orlando

-open the hood.
-under the hood take out eight caps and remove the trim.
-under the trim, Unscrew the four screws.

-around the perimeter of the lower part, Unscrew the screws and take out the caps.
-we release the lining of the arches from the bumper (hold on latches).

-turn the wheels to the left or right side, depending on which side we will disassemble first.
-in the wheel wells, Unscrew the screws and release the fender liner.
-for the fender liner, Unscrew one screw on each side (spun up) that attach the corners of the bumper to the wings.

-we release the latches in the wings and under the headlights (pull the corners towards you).
-pulls the bumper forward (be careful not to break the wires).
-remove connectors from electrical equipment (if any).

Rear bumper

-Open the trunk lid.
-remove the rear lights.

-we release from the latches in the bumper lining arches.
- Unscrew the screws in the wheel arches.

-at the bottom, Unscrew the two screws and take out the two pistons (twisted and inserted from the bottom up).
-we release the latch in the wings (pull the corners towards you) and under the rear lights.

-remove the bumper back (be careful not to break the wires).
-remove connectors from electrical equipment (if any).
Tags: