Ford All In One 3.2 binding lost keys Ford Full

Ford All In One 3.2 binding lost Ford keys - Ford Transit Connect 2005-2010, 2006-2009 Ford Fiesta, Ford Fusion 2006-2009, Ford Mondeo 2008+, Ford Galaxy 2008+,
Ford S-Max 2008+

Supported ECUs:

SID804, EDC16, SID206, SID202, SID803, SIM210,

How to use this program:

- if the car key transponder is lost:

read the tool inst cluster EEPROM by obd2 (or you can remove the IC from the car and read the hc12 processor by programming the EEPROM with
any programmer (like CarProg, Xprog or UPA), save the file and open it with "open dump microcircuits". The program will show you the transponder
data. Write this data to eh2 or TPX2 transponder with any transponder programmer (like RW4, Codereader or zedbull button).

If the Engine ECU Immobilizer Lamp shows a malfunction:

check out the tool inst cluster EEPROM by obd2 (or you can remove the IC from the car and read the hc12 processor by programming the EEPROM with
any programmer (like CarProg, Xprog or UPA), save the file and open it with "open chip dump".
Open ECU (SID804, edc16, SID206, SIM210) and read EEPROM (with carprog you can read by obd2).
Open the file with the "open ECU EEPROM" button. Now press the synchro button in the ECU (if you want to transfer data from the dashboard
ECU) or Sync (if required for transferring data from the ECU to the instrument cluster) and write the saved file to the dash (if you made a synchronous dash)
or the ECU (if you made the synchronization of the ECU)

How does the Immobilizer work on Ford Mondeo 2008+, Galaxy 2008+, S-Max 2008+:

The immobilizer data (PATS) on these cars is stored in the intelligent power distribution module (GEM) located in the passenger
fuse compartment. (GEM) will receive the transponder key signal from the immobilizer coil and if the key fits, sends a
synchronization signal to the engine ECU.
If the key is stored in the GEM and the synchronization of the ECU data is correct, the GEM allows you to start the engine.

How to use this program:
If the car key transponder is lost:

1. Remove the GEM (power distribution unit) from the car.
2. Open and find the 25320 EEPROM. Read (with carprog you can read in chain).
3. Save file and open with "open treasure eeprom". The program will show you the transponder data.
4. Write this data to the head of the eh2 or TPX2 transponder with any transponder programmer (like RW4, Codereader or zedbull button)

If the engine ECU is faulty/lost:

1. Remove the gem (intelligent power distribution module) from the car.
2. Open and find 25320 eeprom. Read (with carprog you can read in the chain).
3. Save file and open with "open treasure eeprom".
4. Open the ECU and read the EEPROM.
5. Open file with "open ECU eeprom" button.
6. Now transfer synchronization data from the GEM to the engine ECU with the synchro button in the ECU.
7. Save ECU file and write again with the engine control module