How to remove front and rear bumper SEAT Cordoba (after 2003)

Depending on the year of manufacture and model variant, the mounting locations differ.

-unscrew the four screws under the hood (if there are any, pull out the pins).
-unscrew the two screws at the edges of the central lower decorative grille.
-unscrew the screws around the perimeter at the bottom of the bumper (screwed from bottom to top).
-turn the wheels to the left or right side, depending on which side we will disassemble first.

-in the wheel arches, unscrew the screws that secure the mudguards.
-with an assistant, pull the edges of the bumper to the sides, tearing them off the latches, and pull them off the guides towards you.
-remove the connector from the parking sensors (if any).
-if there are headlight washers, disconnect the hoses. To prevent the liquid from leaking out, you need to prepare a plug or container in advance.
-remove the connector from the fog lights.

Rear bumper

Depending on the year of manufacture and model variant, the mounting locations differ.

-unscrew the screws in the wheel arches that secure the mudguards (in order not to remove the wheels, it is more convenient to unscrew them with a ratchet with a nozzle).
-move the mudguards to the side and unscrew one screw on each side.
-unscrew the two screws that secure the lower skirt (there may be pistons).
-unscrew the screws around the perimeter at the bottom (screwed from bottom to top).

-with an assistant, pull the bumper off the guides towards you.
-remove the connector from the license plate light.
-remove the connector from the parking sensors (if any).
Tags: