СarSoftos.com » How To Remove Bumpers » How to remove the front and rear bumper AUDI A8 D3

How to remove the front and rear bumper AUDI A8 D3

Author: carsoftos777 | 17-04-2023, 17:34 | How To Remove Bumpers | Views: 445 | Comments: 0 | Found a bug?
How to remove the front and rear bumper AUDI A8 D3


The bumper is removed together with the grille (beard).

-under the hood, Unscrew the upper bolts that secure the grille and the upper part of the bumper to the body.
-at the very bottom of the bumper along the entire length we take out the caps that secure the engine protection and fender liner.
-Unscrew the wheels left or right, depending on which side of the bumper will be unscrewed first.
-in the wheel arches, Unscrew the screws and take out the caps that attach the fender liner to the bumper.

-Now the hardest part, you need to unscrew the three nuts on each side that attach the bumper to the fenders. You will need a head for 10 with an extension cord (about 30 cm) and a ratchet. Move the fender liner to the side and unscrew the nuts. In some models, depending on the engine, there may be a washer reservoir or a charcoal filter under the wing, which make it difficult to access the nuts.
-pull off the bumper from the side latches.
-carefully pull the bumper towards you (it is advisable to do this together, so as not to scratch the paint on the wings with studs).
-Now you can disconnect the connectors from the fog lights.
- if there are headlight washers, disconnect the hoses from the injectors and close them with stoppers so that no liquid flows out of the reservoir.
-remove the bumper

Rear bumper




-in the wheel arches, Unscrew three screws on each side (in order not to remove the wheels, you can use a ratchet with a nozzle).
-at the bottom of the bumper, Unscrew the four screws.
-remove the side trim in the trunk (you need to access the rear lights).
-from the trunk, under the rear lights, you need to loosen the mounting plate (the last photo will be more clear). To do this, turn the screw on the pad two turns, on the left side counterclockwise on the right side clockwise.

-if there is parking sensors, you need to disconnect the common connector.
-remove the edges of the bumper from the rails.
-pulls the bumper towards you (better to do it together, so as not to scratch the paint on the wings).
  • LIKE
  • 1

Tags:
Information
Users of Guests are not allowed to comment this publication.