How to remove front and rear bumper BMW 3-series E90

-along the entire length of the lower part of the bumper, Unscrew the seven screws (spun up).
-Unscrew the wheels left or right, depending on which side you will unscrew first, and in the wheel arches, Unscrew the screws that attach the fender liner to the bumper.
-move the edges of the fender liner to the side and Unscrew two bolts on each side that secure the bumper to the wings (spun up).
-under the hood, Unscrew the four bolts that secure the upper part of the bumper.
-pulls the bumper over.

-remove the connectors from the fog lights.
-if there are headlight washers, remove the hoses from the nozzles (if there is liquid in the tank, it will flow through the removed hoses).
- bumper removed.

Rear bumper

-in the wheel wells, Unscrew the screws that secure the fender liner (in order not to remove the wheels, you can use a ratchet with a nozzle).
-move the fender liner to the side and Unscrew the bolt that is screwed into the wing from the bottom up (one bolt on each side).
-along the entire length of the lower part of the bumper, Unscrew the eleven screws.
-at the level of the corners of the trunk lid, with a thin screwdriver, open the plastic caps and Unscrew the screws under them.
-pull off the bumper from the side latches (pull the edges down and towards you).
-pull off the latches under the rear lights (if not pulled out, you need to pry, such as a ruler).

-pulls the bumper over.
-if there is parking sensors, remove the connector
Tags: