How to remove the front and rear bumper AUDI A5

The bumper is removed along with the grille.
Depending on the year of manufacture and type of model, the attachment points differ slightly.

-under the hood, Unscrew the screws and take out the caps (twisted and inserted from top to bottom) that secure the cover over the grille.
-remove the grille cover.
-under the cover, Unscrew the screws (spun down).
-turn the wheels to the left or right side, depending on which side we will disassemble first.
-in the wheel wells, Unscrew the screws and take out the caps that secure the fender liner.

-move the fender liner to the side and Unscrew two nuts under the headlights (you will need a head with a nozzle).
-Unscrew the screws and take out the caps around the perimeter at the bottom (spun up).
-with an assistant, we tear off the corners from the latches in the wings and pull the bumper from the guides towards ourselves (you should follow the studs under the headlights so as not to scratch the paint on the wings).
- if there are headlight washers, disconnect the hoses. To prevent liquid from leaking to the ground, you need to prepare a suitable container or plug.
-remove the connector from the parking sensors.
-remove the connector from the fog lights (if any).
-remove connectors from additional electrical equipment (if any, depending on the configuration of the car).

Rear bumper

-in the side panels in the trunk, open the covers.
-under the covers, Unscrew the threaded fasteners that secure the rear lights.
-take the lights to the sides and remove from the latches.
-under the rear lights, loosen one screw on each side.
-from the trunk under the rear lights, Unscrew one nut on each side.
-Unscrew the screws in the wheel arches that secure the fender liner (in order not to remove the wheels it is more convenient to unscrew with a ratchet with a nozzle).

-Unscrew the screws around the perimeter at the bottom (spun up).
-with an assistant, we release the bumper from the latches in the wings and pull it from the guides towards ourselves.
-if you have parking sensors, remove the connector (located under the trim in the trunk).
-remove connectors from additional electrical equipment (depending on the configuration of the car).
Tags: