How to remove the front and rear bumper AUDI Q5

The bumper is removed along with the grille.
Depending on the year of manufacture and type of model, the attachment points differ slightly.

-under the hood take out six caps (inserted from top to bottom) and remove the cover over the grille.
-under the cover, Unscrew one screw on each side, near the headlights (spun down) that secure the upper part of the bumper.
-Unscrew the screws and around the perimeter at the bottom (spun up).
-turn the wheels to the left or right side, depending on which side we will disassemble first.
-in the wheel wells, Unscrew the screws that secure the fender liner.

-with an assistant, tear off the corners from the latches in the wings and pull the bumper from the rails towards you.
- if there are headlight washers, disconnect the hoses from the nozzles. To prevent liquid from leaking to the ground, you need to prepare a suitable container or plug.
-remove the connector from the parking sensors.
-remove the connector from the fog lights (if any).
-remove connectors from additional electrical equipment (if any, depending on the configuration of the car).

Rear bumper

-in the trunk, move up, remove the rear panel trim (sits very tightly).
-under the skin, in the corners, unscrew two nuts on each side (you will need a head with a ratchet).
-Unscrew the screws in the wheel arches that secure the fender liner (in order not to remove the wheels it is more convenient to unscrew with a ratchet with a nozzle).
-Unscrew the screws around the perimeter at the bottom (spun up).
-take out one piston on each side under the rear lights (may not be).

-with an assistant, we release the bumper from the latches in the wings and pull it from the guides towards ourselves.
-if you have parking sensors, remove the connector (located under the trim in the trunk).
-remove connectors from additional electrical equipment (depending on the configuration of the car).
Tags: