How to remove the front and rear bumper AUDI 80 B4

-in the center of the bumper at the very bottom, unscrew the bolt (under the curly screwdriver)
-along the edges of the front part of the bumper, remove the decorative grilles (if any) and unscrew the two bolts with a hex head (usually 6mm), they are twisted from the bottom up.
-pull off the edges of the bumper from the side locks (pull the edge of the bumper down and towards you)
- now you can disconnect the connectors from the fog lights and direction indicators (if any)

- if there are headlight washers, disconnect the hoses from the nozzles and close them with stoppers so that no liquid flows out of the reservoir
-remove the bumper




-remove the lining of the rear of the trunk (where the lock is)
-under the casing, unscrew the four nuts (approximately at the level of the edges of the trunk lid), you will need a head, a ratchet and an extension cord
-Unscrew the screws connecting the bumper with fender liner
- pull off the edges of the bumper from the side locks (pull the edge of the bumper down and towards you)
-remove the bumper
Tags: