How to remove front and rear bumper Saab 9-2X

-open the hood.
-under the hood, take out six pins that secure the upper part.
-along the perimeter of the lower part, take out seven pins that secure the lower part.
-turn the wheels to the side.
-in the wheel arches, take out the pins and release the fender liners (front part).
-move the fender liners to the side and unscrew one screw (pin) at a time that secures the corners of the bumper to the fenders.
-release the latches in the wings (pull the corners down and towards you).
-with an assistant, pull the bumper forward (watch the wires).
-disconnect the electrical equipment connectors.

-open the trunk lid.
-remove the rear panel trim.
-behind the trim, below the taillights, unscrew two nuts on each side.
-remove the taillights.
-in the opening of the taillights, unscrew one nut and pull out two pins on each side.
-along the perimeter of the lower part, pull out the pins and unscrew the screws.
-in the wheel arches, release the mudguards and release the fasteners of the bumper corners to the fenders.
-with an assistant, carefully pull the bumper back.
-disconnect the electrical equipment connectors (if any).