How to remove the front and rear bumper Renault Twingo 3 (after 2014)

-open the hood.
-under the hood, unscrew the four screws that secure the upper part.
-release the hood lock cable.
-unscrew the screws around the perimeter of the lower part that secure the protection.
-turn the wheels to the side.

-release the fender liners (front part) in the wheel arches.
-unscrew one screw on each side behind the fender liners that secure the corners of the bumper to the fenders.
-release the latches in the fenders (pull the corners towards you).
-pull the bumper forward (look for the wires).
-disconnect the electrical equipment connectors (if any).

-open the trunk lid.
-unscrew the screws through the hatches in the side trim of the trunk.
-remove the taillights.
-under the rear lights, pull out the pins.

-unscrew the four screws in the trunk opening.
-from the bottom side, unscrew the five screws that secure the lower part.
-in the wheel arches, unscrew two screws that secure the mudguards and one screw that secures the corners of the bumper to the fenders.
-remove the license plate and unscrew the screw under it.
-release the latches in the fenders (pull the corners towards you).
-with an assistant, pull the bumper back (watch the wires).
-disconnect the license plate light connectors.