How to remove the front and rear bumper Suzuki Forenza (Reno)

- open the hood.
- under the hood we take out the pins (unscrew the screws) that secure the upper part of the bumper (radiator grille).
-unscrew the screws and nuts and remove the headlights.

-in the headlight openings, pull out one piston on each side.
-pull out the pistons and unscrew the screws (inserted and screwed from the bottom up) along the perimeter of the lower part.
- we turn out the wheels depending on which side we will disassemble.

- in the wheel arches we unscrew the screws that secure the fender liners.
- behind the fender liners, unscrew the screws (screwed from the bottom up), which secure the corners of the bumper to the fenders.

- with an assistant, carefully pull the bumper forward (be careful not to break the wires).
- remove the connectors from the electrical equipment (if any).

- open the trunk lid.
- remove the trim in the trunk.
-unscrew the screws and nuts behind the trim.

-pull out the pins around the perimeter of the lower part (inserted from bottom to top).
-unscrew the screws in the wheel arches that secure the fender liners.
- behind the fenders, unscrew one screw on each side (screwed from the bottom up), which secure the corners of the bumper to the fenders.

- with an assistant, carefully pull the bumper back.
- disconnect the electrical equipment connectors (if any).