How to remove the front and rear bumper of a Toyota Urban Cruiser
2-04-2025, 03:16. Posted by: carsoftos777
-turn the wheels to the left or right side, depending on which side we will disassemble first.
-unscrew the screws in the wheel arches and pull out the pins that secure the fender liners to the bumper and the bumper to the fenders.
-open the hood and pull out the pins (inserted from top to bottom) that secure the upper part.
-unscrew the screws around the perimeter of the lower part (screwed from bottom to top).
-with an assistant, release the corners from the latches in the fenders and remove the bumper from the guides towards you.
-remove the connector from the fog lights (if any).
-remove the connector from the parking sensors (if any).
-if there are headlight washers, disconnect the hoses (to prevent the liquid from leaking onto the ground, you should prepare a special container).
Rear bumper
-open the trunk lid.
- in the trunk opening, under the rear lights, we pull out the plugs.
- under the plugs, we unscrew one screw on each side.
- in the wheel arches, we pull out the pins that attach the fender liners to the bumper.
- along the perimeter in the lower part, we pull out the pins (inserted from the bottom up).
- with an assistant, we release the bumper from the latches in the fenders and under the rear lights, remove it from the guides towards ourselves.
- remove the connector from the parking sensors (if any).
- remove the connectors from the additional equipment (if any).
come back