How to remove front and rear bumper Toyota Picnic
27-03-2025, 03:32. Posted by: carsoftos777
-open the hood and pull out three pistons behind the front bar that secure the upper part of the bumper.
-unscrew the screws along the perimeter of the lower part (screwed from the bottom up).
-turn the wheels to the left or right side, depending on which side we will disassemble first.
-in the wheel arches, pull out the clips and unscrew the screws that secure the fender liners to the bumper.
-move the fender liners to the side and unscrew one screw on each side (screwed from the bottom up), which secure the corners to the fenders.
-with an assistant, remove the bumper from the guides towards you.
-remove the connector from the fog lights (if any).
-remove the connector from the parking sensors (if any).
-if there are headlight washers, disconnect the hoses (to prevent the liquid from leaking onto the ground, you should prepare a special container or bend the hose).
Rear bumper
-open the trunk lid and pull out the pins in the opening (inserted from top to bottom).
- in the wheel arches, unscrew the screws and pull out the pins that secure the fender liners and mudguards (if any).
- move the fender liners to the side and unscrew one screw on each side (screwed from the bottom up), which secure the corners of the bumper to the fenders.
- unscrew the screws along the perimeter at the bottom (screwed from the bottom up).
- with an assistant, release the latches in the fenders and pull the bumper off the guides towards you.
- remove the connector from the parking sensors (if any).
- remove the connectors from the additional electrical equipment (if any).
come back