How to remove the front and rear bumper of a Suzuki Kizashi
27-03-2025, 02:51. Posted by: carsoftos777
-open the hood.
-under the hood, unscrew the three screws that secure the upper part of the bumper.
-unscrew the screws along the perimeter of the lower part (screwed from the bottom up).
-turn out the wheels depending on which side we are going to disassemble.
-in the wheel arches, unscrew the screws and release the fender liners.
-Unscrew one screw on each side behind the fenders (screwed from the bottom up), which secure the corners of the bumper to the fenders.
-Release the latches in the fenders (pull the corners towards you).
-With an assistant, carefully pull the bumper forward (be careful not to tear the wires).
-Remove the connectors from the electrical equipment (if any).
Rear bumper
-open the trunk lid.
-unscrew two screws in the trunk opening.
-unscrew the nuts from the trunk and remove the taillights.
-under the taillights, unscrew one screw on each side.
-unscrew the screws along the perimeter of the lower part and pull out the pins (screwed and inserted from the bottom up).
-in the wheel arches, pull out the pins that secure the fender liners.
Suzuki Kizashi taillight mounting diagram - unscrew one screw on each side that secure the bumper corners to the fenders.
-release the latches in the fenders (pull the corners of the bumper towards you) and under the taillights.
-with an assistant, carefully pull the bumper back.
-disconnect the electrical equipment connectors (if any).
come back