How to Remove Front and Rear Bumper Toyota Corolla (2000-2006)
16-03-2025, 04:45. Posted by: carsoftos777
-Under the hood, unscrew the two screws and pull out the piston (screwed and inserted from top to bottom), which secure the radiator grille.
-Release the latches in the bumper and remove the radiator grille.
-Along the perimeter of the lower part, unscrew the screws and pull out the pistons (screwed and inserted from bottom to top).
-Turn the wheels to the left or right side, depending on which side we will disassemble first.
-in the wheel arches, unscrew the screws that secure the fender liners.
-move the fender liners to the side and unscrew one screw on each side that secure the corners to the fenders.
-with an assistant, release the corners from the latches and remove the bumper from the guides towards you.
-remove the connector from the fog lights (if any).
-remove the connector from the parking sensors (if any).
-if there are headlight washers, disconnect the hoses.
Rear bumper
-in the trunk, unscrew the screws and remove the rear and side trims.
-behind the trims, unscrew four nuts (you will need a head with a ratchet), one near the taillights and two in the rear panel.
-in the wheel arches, pull out the pins that secure the fender liners.
-move the fender liners to the side and unscrew one screw on each side that secure the corners to the fenders.
-pull out the pins around the perimeter at the bottom (inserted from bottom to top).
-with an assistant, release the bumper from the latches in the fenders and pull it off the guides towards you.
-remove the connector from the parking sensor (if any).
come back