How to Remove Front and Rear Bumper Toyota Sienna XL20 (2003-2010)
15-02-2025, 00:11. Posted by: carsoftos777
-Under the hood, unscrew the screws (screwed from top to bottom) that secure the upper part of the bumper.
-Along the perimeter of the lower part, unscrew eight screws (screwed from bottom to top).
-Turn the wheels to the left or right, depending on which side we will disassemble first.
-In the wheel arches, unscrew the screws that secure the fender liners to the bumper.
-with an assistant, release the corners from the latches in the wings and remove the bumper from the guides towards you.
-remove the connector from the fog lights (if any).
-remove the connector from the parking sensors (if any).
-if there are headlight washers, disconnect the hoses (to prevent the liquid from leaking onto the ground, you should prepare a special container).
Rear bumper
-open the trunk lid and pull out the pins in the opening.
-in the corners of the opening, pull out the plugs and unscrew the screws under them.
-in the wheel arches, unscrew the screws and pull out the pins that secure the fender liners and mudguards to the bumper (in order not to remove the wheels, it is more convenient to unscrew with a ratchet with a nozzle).
-along the perimeter in the lower part, unscrew the screws and pull out the pins (screwed and inserted from the bottom up).
-with an assistant, release the bumper from the latches in the fenders and remove it towards you.
-remove the connector from the parking sensor (if any).
-remove the connectors from the additional equipment (if any).
come back