How to remove the front and rear bumper SEAT Toledo IV (since 2011)
5-02-2025, 01:27. Posted by: carsoftos777
The bumper is removed together with the radiator grille.
- under the hood, pull out the pins and remove the bar above the radiator grille.
- under the bar, unscrew the screws (screwed from top to bottom) and disconnect the latches that secure the radiator grille and bumper to the body.
- unscrew the screws at the bottom (screwed from bottom to top).
- turn the wheels to the left or right side, depending on which side we will disassemble first.
- in the wheel arches, unscrew the screws that secure the fender liners.
- move the fender liners to the side and unscrew two screws on each side that secure the bumper to the fenders.
-with an assistant, we tear off the corners from the latches and pull the bumper off the guides towards ourselves.
-remove the connector from the parking sensors (if any).
-remove the connector from the fog lights.
-if there are headlight washers, disconnect the hose from the pump. To prevent the liquid from leaking onto the ground, you need to prepare a suitable container.
Rear bumper
Depending on the model variant, the mounting locations may differ.
- in the trunk opening, unscrew two screws on each side that secure the taillights.
- remove the taillights (fastened with latches).
- unscrew the screws in the wheel arches that secure the mudguards to the bumper (in order not to remove the wheels, it is more convenient to unscrew with a ratchet with a nozzle).
- move the mudguards to the side and unscrew one screw on each side (may not be present).
- unscrew the screws along the perimeter at the bottom (screwed from bottom to top).
-with an assistant, release the bumper from the latches in the fenders and under the taillights and pull it off the guides towards you.
-remove the connector from the license plate light.
-remove the connectors from the parking sensors (if any).
come back