How to remove the front and rear bumper of a Toyota Aygo
31-01-2025, 21:54. Posted by: carsoftos777
-Under the hood, unscrew the two screws and pull out two pistons (screwed and inserted from top to bottom), which secure the radiator grille to the upper bar.
-Under the car, unscrew the screws around the perimeter (screwed from bottom to top), which secure the lower part.
-Turn the wheels to the left or right side, depending on which side we will disassemble first.
-In the wheel arches, unscrew the screws that secure the fender liners.
-Move the fender liners to the side and unscrew one screw on each side (screwed from bottom to top) (there may be pistons), which secure the corners to the guides.
-with an assistant, we break the latches in the wings and pull the bumper off the guides towards ourselves.
- if there are headlight washers, disconnect the hoses. You should prepare a container for the windshield wiper in advance.
- remove the connector from the parking sensors (if any).
- remove the connector from the fog lights (if any).
Rear bumper
Depending on the year of manufacture, the mounting locations differ.
- open the trunk lid and unscrew one screw on each side near the taillights in the opening.
- remove the side trim in the trunk (you need to get access to the back of the taillights).
- unscrew the nuts and remove the taillights.
- pull out the pins under the taillights.
- unscrew the screws in the wheel arches that secure the mudguards.
- move the mudguards to the side and pull out one pin on each side that secure the corners to the guides.
- pull out the pins and unscrew the screws along the perimeter in the lower part (inserted and screwed from the bottom up) (there may only be pins).
-with an assistant, release the bumper from the latches and pull it off the guides towards you.
-remove the connector from the license plate light.
-if there is a parking sensor, remove the connector.
come back