How to remove front and rear bumper Toyota Venza
29-12-2024, 02:22. Posted by: carsoftos777
-turn the wheels to the left or right side, depending on which side we will disassemble first.
-unscrew the screws in the wheel arches and pull out the pins that secure the fender liners to the bumper.
-unscrew the screws under the hood and pull out the pins (screwed in and inserted from top to bottom), which secure the trim and the radiator grille.
-remove the radiator grille.
-unscrew three screws under the radiator grille (screwed in from top to bottom).
-unscrew the screws along the perimeter of the lower part (screwed from the bottom up).
-with an assistant, release the corners from the latches in the wings and remove the bumper from the guides towards you.
-remove the connector from the fog lights (if any).
-remove the connector from the parking sensors (if any).
-if there are headlight washers, disconnect the hoses (to prevent the liquid from leaking onto the ground, you should prepare a special container).
Rear bumper
-open the trunk lid.
-in the trunk opening under the taillights, pull out the plugs and unscrew the four screws.
-in the wheel arches, unscrew the screws that secure the fender liners to the bumper.
-unscrew the screws around the perimeter in the lower part (screwed from the bottom up).
-with an assistant, release the bumper from the latches in the fenders, under the taillights and in the trunk opening, remove it from the guides towards you.
-remove the connector from the parking sensor (if any).
-remove the connectors from the additional equipment (if any).
come back