How to remove front and rear bumper Peugeot 4008
18-08-2024, 03:24. Posted by: carsoftos777
-we pull out eleven pistons along the perimeter of the lower part.
-we open the hood.
-we pull out ten pistons under the hood and remove the trim.
-under the lining we pull out two pistons and unscrew three screws.
-depending on which side we will disassemble, we turn out the wheels.
-in the wheel arches we release the wing linings (they are held on by latches, you do not need to remove them completely).
- behind the pads, unscrew one screw on each side that secure the corners of the bumper to the fenders.
- remove the license plate.
- unscrew the two screws under the license plate.
- release the latches in the fenders (pull the corners towards you).
- release the latches under the headlights.
- pull the bumper forward (be careful not to tear the wires and hoses).
- remove the connectors from the fog lights (if any).
- disconnect the washer hoses (fluid may leak).
Rear bumper
- open the trunk lid.
- remove the taillights.
- pull out the pins under the taillights.
- unscrew the screws in the trunk opening.
-pull out the pins along the perimeter of the lower part (inserted from the bottom up).
-release the wing pads.
-unscrew one screw on each side behind the pads, which secure the corners of the bumper to the fenders.
-with an assistant, release the latches in the fenders (pull the corners to the sides).
-carefully (be careful not to tear the wires) pull the bumper back.
-remove the connectors from the electrical equipment.
come back