Главная > How To Remove Bumpers > How to remove the front and rear bumper of an Acura ZDX
How to remove the front and rear bumper of an Acura ZDX19-04-2024, 02:50. Posted by: carsoftos777 |
![]() -open the hood. -under the hood, take out ten pistons and remove the trim above the radiator grille. ![]() -under the trim, Unscrew the six screws that secure the upper part. ![]() -around the perimeter of the lower part, unscrew two screws and take out six pistons. ![]() -turn out the wheels (depending on which side we will disassemble). -in the wheel arches we take out two pistons on each side and release the fender liners. -behind the fender liners, Unscrew one screw on each side that secures the corners of the bumper to the wings. -we release the bumper from the front guide plate on both sides. -tear off the latches in the wings (pull the corners toward you). ![]() -release the latches under the headlights (pull the corner and pull it forward). -with an assistant, pull the bumper forward (make sure not to tear the wires and hoses). -remove the connectors of the electrical equipment. -disconnect the headlight washer hoses (liquid may leak). ![]()
|