How to remove the front and rear bumper of a Toyota Camry XV50 (from 2011)
8-01-2024, 02:05. Posted by: carsoftos777
-open the hood and unscrew the three screws (twisted from top to bottom) that secure the upper part of the bumper.
-at the very bottom, unscrew the six screws (twisted from bottom to top).
-turn the wheels to the left or right, depending on which side we will disassemble first.
-in the wheel arches we take out the caps that secure the fender liners.
-with an assistant, release the latches in the wings and under the headlights, remove the bumper from the guides toward you.
-if there are headlight washers, disconnect the hoses (the hose will need to be bent or the liquid drained into some container).
-remove the connector from the parking sensors (if equipped).
-remove the connector from the fog lights (if equipped).
-if present, remove the connectors from additional electrical equipment.
Rear bumper
Depending on the year of manufacture and model type, the mounting locations may differ.
-open the trunk lid and in the opening, near the rear lights, use a thin screwdriver to pull out the plugs.
-under the plugs, Unscrew the screws, one on each side.
-in the wheel arches, Unscrew the screws that secure the fender liners.
-move the fender liners to the side and Unscrew one screw on each side that secures the corners to the wings.
- along the perimeter in the lower part, unscrew the screws and take out the caps (twisted and inserted from the bottom up).
-with an assistant, release the bumper from the latches in the wings and under the rear lights, and pull it off the guides towards you.
-if there are parking sensors, remove the connector.
-remove connectors from additional equipment (if any).
come back