How to remove the front and rear bumper AUDI A3
31-03-2023, 15:34. Posted by: carsoftos777
The bumper is removed easily and the whole process does not take much time.
-under the hood take out the caps that attach the bumper to the top frame.
-along the entire length at the bottom of the bumper, Unscrew the screws securing the engine protection to the bumper.
-Unscrew the wheels left or right, depending on which side of the bumper will be unscrewed first.
-Unscrew three screws on each side (usually poses an asterisk) that attach the fender liner to the bumper.
-pull off the edges of the bumper from the side rails.
-pulls the bumper over.
-remove the temperature sensor (in the lower grille on the driver's side).
-now disconnect the connectors from the fog lights (if any).
- if there are headlight washers, disconnect the hoses from the nozzles and close them with stoppers so that no liquid flows out of the reservoir.
- bumper removed.
Rear bumper
-Unscrew the screws and remove the lining under the rear lights and the bar in the middle.
-under the bar, Unscrew the screws.
-under the rear lights, Unscrew the nuts.
-if there is parking sensors, you need to disconnect the common connector.
-at the bottom of the bumper, Unscrew the bolts (if any).
-Unscrew the screws connecting the bumper with the fender liner (in order not to remove the wheels, you can use a ratchet with the desired nozzle).
- pull off the edges of the bumper from the side latches (pull the edge of the bumper towards you).
- bumper removed.
come back