How to remove the front and rear bumper AUDI A6 C4
31-03-2023, 15:29. Posted by: carsoftos777
In my opinion the most successful bumper mounting design. The bumper is removed in 5 minutes but at the same time it is very securely held on the car.
-along the edges of the front part of the bumper, remove the decorative grilles and Unscrew the two bolts with a hex head (usually 6mm), they are twisted from the bottom up.
-pull off the edges of the bumper from the side locks (pull the edge of the bumper down and towards you)
- now you can disconnect the connectors from the fog lights and direction indicators (if any)
-if there are headlight washers, disconnect the hoses from the injectors and close them with stoppers so that no liquid flows out of the reservoir
-remove the bumper
Rear bumper
-remove the lining of the rear of the trunk (where the lock is)
-under the casing, unscrew the four bolts (approximately at the level of the edges of the trunk lid), you will need a head, a ratchet and an extension cord
-Unscrew the screws connecting the bumper with fender liner
- pull off the edges of the bumper from the side locks (pull the edge of the bumper down and towards you)
-remove the bumper
- in station wagons, the bumper mounting bolts can be under the trunk mat.
come back