Главная > How To Remove Bumpers > How to remove the front and rear bumper AUDI A4 B6
How to remove the front and rear bumper AUDI A4 B626-03-2023, 16:12. Posted by: carsoftos777 |
![]() The bumper is not as difficult to remove as it might seem at first glance. -at the edges at the bottom of the bumper, remove the decorative grilles, for this you need to press the latches with a flat screwdriver. -under the gratings, Unscrew the two bolts for the internal hexagon (there are under the asterisk), which are twisted from the bottom up and secure the bumper amplifier to the body (the location of the bolts is indicated by arrows). -Unscrew the wheels left or right, depending on which side of the bumper will be unscrewed first. -Unscrew the screws that secure the fender liner to the bumper. ![]() we take the fender liner to the side, and unscrew three nuts on each side that attach the bumper to the wing (you will need a head with an extension of about 40 cm). -pull off the edges of the bumper from the side locks (pull the edge of the bumper towards you) -pull the bumper towards you (it is advisable to do it together so that the studs do not scratch the paint on the wings). -now you can disconnect the connectors from the fog lights and (if any). - if there are headlight washers, disconnect the hoses from the nozzles and close them with stoppers so that no liquid flows out of the reservoir. - bumper removed. Rear bumper![]() -remove the side trim in the trunk to gain access from the inside to the rear lights. -under the rear lights, Unscrew three nuts on each side (you will need a 10 head with an extension). -Unscrew two nuts on each side under the lights closer to the trunk lid. -if there is parking sensors, you need to disconnect the common connector. -at the bottom of the bumper, Unscrew the bolts under the asterisk (if any). ![]() -Unscrew the screws connecting the bumper with the fender liner (in order not to remove the wheels, you can use a ratchet with the desired nozzle). - pull off the edges of the bumper from the side latches. -remove the bumper (it's better to do it together, so that the studs do not scratch the paint on the wings). come back |